Xerox WorkCentre 52xx EIP Configuration

This document has been created based on Xerox WorkCentre 5230 (FW 1.207.8)

Enabling JBA ("Network accounting")

If JBA technology is required for accounting (you are using MFD specific accounting instead of SNMP or job analysis accounting), it must be turned on.

Furthermore, for Onbox and Offbox user verification has to be set on (otherwise, it has to be set off).

Enable Network Accounting: Properties > Accounting > Accounting Configuration.

images/download/attachments/160482974/image019.png

Enable Custom Services: Properties > Services > Custom Services > *Custom Services.

images/download/attachments/160482974/image020.png

Checking enabled features

Xerox device may come with many options disabled by factory settings. Please ensure following options are enabled:

FTP: Properties > Connectivity > Protocols > FTP

images/download/attachments/160482974/image021.png

Check Export User validation: Properties > Services > Custom Services > Validation Options > Enable Export User Name.

images/download/attachments/160482974/image022.png

Configuring Xerox Secure Access

Xerox secure access: Properties > Security > Remote Authentication Services > Xerox Secure Access Settings.

images/download/attachments/160482974/image028.png

SNMP Community setting

You will later need to fill proper SNMP community in device configuration. You can check current MFD setting under Properties > Connectivity > Protocols > SNMP Configuration > Edit SNMP v1/v2c Properties.

images/download/attachments/160482974/image029-1.png

In device configuration, corresponding Community Name (Read/Write) has to be filled.

images/download/attachments/160482974/image030-1.png

Scan Services

You will need to enable Scan Template management in device configuration for scanning with workflows later. You can check current MFD setting under Properties > Connectivity > Protocols > HTTP. Scan Template Management and Scan Extensions should be enabled (You can check also Security setting – Xerox Secure Access and Authentication & Authorization Configuration).

images/download/attachments/160482974/image031.png

Post-installation checks and additional settings

User access rights must be configured globally (only if LDAP is properly set-up, user logins/aliases can be used for per group access rights but it still has to be configured manually per device).

Authentication mode: Properties > Security > Authentication Configuration

Check current settings and click Next.

images/download/attachments/160482974/image023.png

Click on Configure... button for Service Access.

images/download/attachments/160482974/image2015-2-23_17_46_12.png

Click on Next button for Service Access (on previous page).

a) If you chose device authentication mode To device, make sure that all services are locked.

b) If you chose device authentication mode To each application, make sure that YSoft SafeQ is locked, other services may be unlocked.
images/download/attachments/160482974/image027.png

In case you change title of your application and reinstall the embedded terminal, the YSoft SafeQ application can get unlocked. In that case, please lock the application again manually.